Always test a small sample to ensure that the desired result is achieved before proceeding with the main project. If in doubt, do not proceed.

Do not dilute. The surface to be treated must be dry, free of any other coating materials, free of dirt/dust and also any paint remains/particles. If applicable prepare the surface first. Should there be painted surfaces adjacent to the area to be treated, make an experimental test in a place which is not immediately visible. The product should be used at a temperature above 10 °C. Any plants should be first covered for protection, or generously sprinkled with water to prevent any accidental oxidation/withering. Apply completely covering with a brush and work thoroughly into the wood. On vertical surfaces work from the bottom to the top. Let the coating start working for a period between 1 and 2 hours. Do not let dry out. Apply again if it is going to be dry. Spray the coated area using a pressure jet at an angle of 45 degrees to the treated surface using lots of water. Do not use too much pressure, to prevent damage to the wood fibres. Alternatively use a strong water jet., applying with upward strokes starting from the bottom working upwards, and rinse thoroughly. The quality of the result is more dependent upon the amount of water, rather than the pressure used.

For very heavily soiled surfaces a second treatment may be necessary. The renovation is completed when completely dried. It is essential to wear plastic gloves and protective glasses/goggles together with an overall suit when working with this product because Nanolia Wood Fresh oxidises on the skin or soft membranes. Details in the application vary depending upon the surface to be coated. We are happy to advise you fully in these cases.

After cleaning, we recommend further treatment using either Nanolia Wood Boost or Wood Prodeck AB

The coverage of this product is highly dependent upon the absorbency and structure of the surface to be coated. Generally one litre will cover 5-6 m².

1 litre bottle, 5 litre canister, 10 litre canister. Other packing forms/sizes are possible after prior consultation with us and according to the transport possibilities/regulations.

At least 6 months in a dry place, in the original packing. Protect from frost and direct sunlight.

Disposal: Empty packing may be disposed of in the domestic waste. Remaining product must be disposed of according to the local laws and regulations or it must be taken to the community collection point for such materials.

When using this product please take note of these instructions. We wish to make it clear that the use of chemical preparations should only take place when the safety measures are observed and always out of the reach of children. The technical information given here is according to the latest technical knowledge and compiled from our own experience. In view of the many uses possible with this product it is therefore the responsibility of the user to act according to the given situation in respect of safety – that is to say the user acts on their own responsibility in any given situation when using this product. As the use of this product takes place out of our jurisdiction we have set out safety and protection measures, but we cannot be held responsible in any circumstances. For any misuse of the product we cannot be held responsible. In the event of a new version of this information becoming available – the information set out here is no longer valid.