Always test a small sample to ensure that the desired result is achieved before proceeding with the main project. If in doubt, do not proceed.
Do not dilute. The surface to be treated must be dry, free of dust and dirt with no oil or fats. Work and apply at temperatures above 5°C. Previously applied impregnations or treatments can influence the result. The surface must be acceptable to this product. Apply by spraying evenly from a distance of about 20 cm, and allow drying for approximately 1 hour. After 24hours the full effectiveness of this product is realised. A repeated application or an “ironing-in” (at 80 to 120 °C.) will increase the quality of the result. Alternatively treated textiles can be heat-treated using a (domestic) clothes drier. When the effect has eventually worn down – quite simply refresh, using the treatment method described here. Alternatively you can try to heat again.
The suitability and the colour-fastness of the material to be treated should be tested prior to final application of the product.
Application specifics depend very much upon the surface of the material to be treated, and we will be pleased to give you comprehensive details on this subject.
Depending entirely upon the surface to be treated and the method used, about 10 m² can be treated with one liter of this product.
0,5 litre pump-spray-bottle, 1 litre bottle, 5 litre canister, 10 litre canister. Other packing forms/sizes are possible after prior consultation with us and according to the transport possibilities/regulations.
The product may be stored for at least 12 months in its original packing. Protect from frost and direct sunlight.
Empty containers as well as any remaining product must be disposed of according to the local laws and regulations or it must be taken to the community collection point for such materials.
When using this product please take note of these instructions. We wish to make it clear that the use of chemical preparations should only take place when the safety measures are observed and are always out of the reach of children.
The technical information given here is according to the latest technical knowledge and compiled from our own experience. In view of the many uses possible of this product it is the responsibility of the user to act according to the given situation in respect of safety – that is to say the user acts upon their own responsibility in any given situation when using this product. As the use of this product takes place out of our jurisdiction, we have set out safety and protection measures, but we cannot be held responsible in any circumstances. For any misuse of the product we cannot be held responsible. In the event of a new version of this information becoming available – this information here set out is no longer valid.
Its anti-adhesive components give treated textiles a breathing surface that allows water vapour to pass through while at the same time preventing the passage of water or the adhesion of oil, dirt and dust. Easy to apply, it contains no waxes or silicones and can be washed up to 10 times before retreatment is necessary.